Command Line Reference Guide

Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
dot1p priority traffic on the switch is scheduled to the current queue mapping.
dot1p priorities within the same queue must have the same traffic properties and
scheduling method.
ETS-assigned scheduling applies only to data queues, not to control queues.
The configuration of bandwidth allocation and strict-queue scheduling is not
supported at the same time for a priority group. If you configure both, the
configured bandwidth allocation is ignored for priority-group traffic when you
apply the output policy on an interface.
Related
Commands
• qos-policy-output ets — configures the ETS bandwidth allocation.
• bandwidth-percentage — bandwidth percentage allocated to priority traffic in
port queues.
set-pgid
Configure the priority-group identifier.
Syntax
set-pgid value
To remove the priority group, use the no set-pgid command.
Parameters
value Enter the priority group identification. The range is from 0 to
7.
Defaults none
Command
Modes
PRIORITY-GROUP
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Related
Commands
• priority-group qos-policy — creates an ETS priority group.
Data Center Bridging (DCB)
439