Command Line Reference Guide

ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another
multicast router that should be the querier.
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout
command.
Parameters
seconds Enter the number of seconds the router must wait to
become the new querier. The range is from 60 to 300. The
default is 125 seconds.
Defaults 125 seconds
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval
command.
Parameters
seconds Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is 60 seconds.
Defaults 60 seconds
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Internet Group Management Protocol (IGMP)
547