Command Line Reference Guide

To delete a specific multicast router interface, use the no igmp snooping
mrouter interface interface command.
Parameters
interface
interface
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Defaults Not configured.
Command
Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The Dell Networking OS provides the capability of statically configuring the
interface to which a multicast router is attached. To configure a static connection
to the multicast router, enter the ip igmp snooping mrouter interface
command in the VLAN context. The interface to the router must be a part of the
VLAN where you are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp
snooping querier command.
Defaults Not configured.
Command
Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This
behavior is useful when there is no multicast router present in the VLAN because
the multicast traffic is not routed. Assign an IP address to the VLAN interface for the
switch to act as a querier for this VLAN.
Internet Group Management Protocol (IGMP)
551