Command Line Reference Guide

rate-interval
Configure the traffic sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data.
The range is from 5 to 299 seconds.
NOTE: For 0 to 5 seconds, polling occurs every 5
seconds. For 6 to 10 seconds, polling occurs every 10
seconds. For any other value, polling occurs every 15
seconds.
Defaults 299 seconds
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The output of the show interfaces command displays the configured rate
interval, along with the collected traffic data.
Related
Commands
show interfaces — displays information on physical and virtual interfaces.
show config
Display the interface configuration.
Syntax
show config
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-if)#show conf
!
interface GigabitEthernet 1/7
no ip address
switchport
no shutdown
Dell(conf-if)#
578
Interfaces