Command Line Reference Guide

Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show interface status
Port Description Status Speed Duplex Vlan
Te 0/1 Down Auto Auto --
Te 0/2 Down Auto Auto --
Te 0/3 Down Auto Auto --
Te 0/4 Down Auto Auto --
Te 0/5 Down Auto Auto --
Te 0/6 Down Auto Auto --
Te 0/7 Down Auto Auto --
Te 0/8 Up 10000 Mbit Full --
Te 0/9 Down Auto Auto --
Te 0/10 Down Auto Auto --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
Te 0/13 Down Auto Auto --
Te 0/14 Down Auto Auto --
Te 0/15 Down Auto Auto --
Te 0/16 Up 10000 Mbit Full --
Dell#
Related
Commands
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode
interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• Enter the keyword backup to view the backup interface
for this interface.
Interfaces
589