Command Line Reference Guide

802.1QTagged: True
Vlan membership:
Q Vlans
Dell#
Related
Commands
interface — configures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces transceiver — displays the physical status and operational status of
an installed transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port] transceiver
Parameters
tengigabitether
net
For a 10G interface, enter the keyword
tengigabitethernet then the slot/port information.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the
slot/port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show interfaces transceiver command shown
in the following example.
Line Description
Rx Power
measurement
type
Output depends on the vendor, typically either “Average” or
“OMA” (Receiver optical modulation amplitude).
Temp High Alarm
threshold
Factory-defined setting, typically in Centigrade. Value differs
between SFPs and SFP+.
Voltage High
Alarm threshold
Displays the interface index number used by SNMP to
identify the interface.
Interfaces
591