Command Line Reference Guide

Defaults auto
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is found on the 1000/10000 Base-T Ethernet interfaces.
When you enable auto, the system performs an automatic discovery to determine
the optics installed and configure the appropriate speed.
When you configure a speed for the 1000/10000 interface, confirm the negotiation
auto command setting. Both sides of the link must have auto-negotiation either
enabled or disabled. For speed settings of 1000 or auto, the software sets the link
to auto-negotiation and you cannot change that setting.
Related
Commands
duplex (1000/10000 Interfaces) — configures duplex mode on physical interfaces
with the speed set to 10/100.
negotiation auto — enables or disables auto-negotiation on an interface.
stack-unit portmode
Split a single 40G port into 4-10G ports on the MXL switch.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member
to reset. The range is 0 to 5.
NOTE: The MXL switch commands accept Unit ID
numbers from 0 to 5, though the MXL switch supports
stacking up to three units only with the Dell Networking
OS version 8.3.7.1.
number Enter the port number of the 40G port to be split. Enter one
of the following port numbers for the MXL switch: 48, 52, 56,
or 60.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
598
Interfaces