Command Line Reference Guide

ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Syntax
p domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To fully enable DNS, also specify one or more domain name servers with the ip
name-server
command.
The Dell Networking OS does not support sending DNS queries over a VLAN. DNS
queries are sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
ip name-server — specifies a DNS server.
show hosts — Views the current bindings.
ip domain-name
Configure one domain name for the switch.
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
IPv4 Routing
625