Command Line Reference Guide

Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Using the following example of a static route: ip route 33.33.33.0 /24
tengigabitethernet 0/0 172.31.5.43
• The software installs a next hop that is not on the directly connected subnet but
which recursively resolves to a next hop on the interface’s configured subnet. In
the example, if gig 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43
recursively resolves to 2.2.2.0, the system installs the static route.
• When the interface goes down, the system withdraws the route.
• When the interface comes up, the system re-installs the route.
• When recursive resolution is “broken,” the system withdraws the route.
• When recursive resolution is satisfied, the system re-installs the route.
Related
Commands
show ip route — views the switch routing table.
ip source-route
Enable the system to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip tcp initial-time
Define the wait duration in seconds for the TCP connection to be established. This command is
supported on the MXL platform.
Syntax
ip tcp initial-time <8-75>
To restore the default behavior, which causes the wait period to be set as eight
seconds, use the no ip tcp initial-time command.
IPv4 Routing
633