Command Line Reference Guide

Example
(Member-Info)
Dell#show ip cam stack-unit 0 po 0 ecmp-group member-info
detail
Group Index Member Count Mac-Addr Port VLan ID Gateway
----------- ------------------------------- ------------------
0 2 00:01:e8:8a:d6:58 Te 0/3
0 1.1.1.2
00:01:e8:8a:d6:58 Te 0/8 0 2.1.1.2
Dell#
show ip fib stack-unit
View all FIB entries.
Syntax
show ip fib stack-unit 0–5 [ip-address [mask] [longer-prefixes]
| summary]
Parameters
0–5 Enter the unit ID, from 0 to 5.
ip-address
mask
(OPTIONAL) Enter the IP address of the network destination
to view only information on that destination. Enter the IP
address in dotted decimal format (A.B.C.D). Enter the mask in
slash prefix format (/X).
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
summary (OPTIONAL) Enter the keyword summary to view the total
number of prefixes in the FIB.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip fib stack-unit command shown in the
following example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
642
IPv4 Routing