Command Line Reference Guide

Fields Description
Method Displays “Manual” if the configuration is read from the saved
configuration.
Status States whether the interface is enabled (up) or disabled
(administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the
interface.
Example (Brief)
Dell#show ip int brief
Interface IP-Address OK? Method
Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively
down down
GigabitEthernet 1/1 unassigned NO Manual administratively
down down
GigabitEthernet 1/2 unassigned YES Manual
up up
GigabitEthernet 1/3 unassigned YES Manual
up up
GigabitEthernet 1/4 unassigned YES Manual
up up
GigabitEthernet 1/5 10.10.10.1 YES Manual
up up
GigabitEthernet 1/6 unassigned NO Manual administratively
down down
show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
static (OPTIONAL) Enter the keyword static to view non-active
routes also.
Command
Modes
• EXEC
• EXEC Privilege
IPv4 Routing
645