Command Line Reference Guide

Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external
type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type
1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS
level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * -
candidate default,
Gateway of last resort is not set
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
C 100::/64 [0/0]
Direct, Te 0/12, 20:00:18
C 400::/64 [0/0]
Direct, Tu 1, 00:09:02
S 800::/64 [1/0]
via 100::1, Te 0/12, 00:00:50
L fe80::/10 [0/0]
Direct, Nu 0, 20:00:18
Dell#
Example
(Summary)
Dell#show ipv6 route summary
Route Source Active Routes Non-active Routes
connected 3 0
static 1 0
Total 4 0
Total 4 active route(s) using 928 bytes
Dell#
trust ipv6-diffserv
Allows the dynamic classification of IPv6 DSCP.
Syntax
trust ipv6-diffserv
To remove the definition, use the no trust ipv6-diffserv command.
Defaults none
Command
Modes
CONFIGURATION-POLICY-MAP-IN
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you configure trust IPv6 diffserv, matched bytes/packets counters are not
incremented in the show qos statistics command.
Trust diffserv (IPv4) can co-exist with trust ipv6-diffserv in an Input Policy Map.
Dynamic classification happens based on the mapping as shown:
IPv6 Basics
691