Command Line Reference Guide

neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor {ipv6-address | peer-group-name} route-reflector-
client
To indicate that the neighbor is not a route reflector client or to delete a route
reflector configuration, use the no neighbor {ipv6-address | peer-group-
name} route-reflector-client command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group. All routers in the peer
group receive routes from a route reflector.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The first time you enter this command it configures the neighbor as a route
reflector and members of the route-reflector cluster. Internal BGP (IBGP) speakers
do not need to be fully meshed if you configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route
reflector.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address [route-map map-name]
To remove a network, use the no network ipv6-address [route-map map-
name] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
772
IPv6 Border Gateway Protocol (IPv6 BGP)