Command Line Reference Guide

Parameters
level-1 Allows a router to act as a Level 1 router.
level-1-2 Allows a router to act as both a Level 1 and Level 2 router.
This setting is the default.
level-2-only Allows a router to act as a Level 2 router.
Defaults level-1-2
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The IS-IS protocol automatically determines area boundaries and are able to keep
Level 1 and Level 2 routing separate. Poorly planned use of this feature may cause
configuration errors, such as accidental area partitioning.
If you are configuring only one area in your network, you do not need to run both
Level 1 and Level 2 routing algorithms. You can configure the IS type as Level 1.
log-adjacency-changes
Generate a log messages for adjacency state changes.
Syntax
log-adjacency-changes
To disable this function, use the no log-adjacency-changes command.
Defaults Adjacency changes are not logged.
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command allows you to monitor adjacency state changes, which are useful
when you monitor large networks. Messages are logged in the system’s error
message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
Intermediate System to Intermediate System (IS-IS)
817