Command Line Reference Guide

show mac learning-limit
Display MAC address learning limits set for various interfaces.
Syntax
show mac learning-limit [violate-action] [detail] [interface
interface]
Parameters
violate-action (OPTIONALY) Enter the keywords violate-action to
display the MAC learning limit violation status.
detail (OPTIONAL) Enter the keyword detail to display the MAC
learning limit in detail.
interface
interface
(OPTIONAL) Enter the keyword interface with the
following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Dell#
Virtual LAN (VLAN) Commands
The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and
use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP,
ACLs and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN
interface may continually switch between Master and Backup.
NOTE: For more information, refer to VLAN Stacking and VLAN-related commands, such as
portmode hybrid in the Interfaces chapter.
856
Layer 2