Command Line Reference Guide

#
Related
Commands
show ip ospf database — displays OSPF database information.
show ip ospf interface
Display the OSPF interfaces configured. If OSPF is not enabled on the switch, no output is generated.
Syntax
show ip ospf process-id interface [interface]
Parameters
process-id Enter the OSPF process ID to show a specific process. If you
do not enter a process ID, the command applies only to the
first OSPF process.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the null interface, enter the keyword null then zero
(0).
• For Loopback interfaces, enter the keyword loopback
then a number from 0 to 16383.
• For Port Channel groups, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip ospf process-id interface command
shown in the following example.
Item Description
GigabitEthernet... This line identifies the interface type slot/port and the status
of the OSPF protocol on that interface.
Internet Address... This line displays the IP address, network mask and area
assigned to this interface.
970
Open Shortest Path First (OSPFv2 and OSPFv3)