Command Line Reference Guide

you enable authentication on an area with the area authentication command,
you do not enable encryption at the same time.
If you have enabled IPsec authentication in an OSPFv3 area with the area
authentication
command, you cannot use the area encryption command in
the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over
an area-level configuration. If you remove an interface configuration, an area
encryption policy that has been configured is applied to the interface.
clear ipv6 ospf process
Reset an OSPFv3 router process without removing or re-configuring the process.
Syntax
clear ipv6 ospf process
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
debug ipv6 ospf bfd
Display debug information and interface types for BFD on OSPF IPv6 packets.
Syntax
[no] debug ipv6 ospf bfd [interface]
To cancel the debug command, use the no debug ipv6 ospf command.
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a tunnel interface, enter the keyword tunnel then a
number. The range is from 1 to 16383.
984
Open Shortest Path First (OSPFv2 and OSPFv3)