Command Line Reference Guide

ipv6 ospf area
Enable IPv6 OSPF on an interface.
Syntax
ipv6 ospf process id area area id
To disable OSPFv6 routing for an interface, use the no ipv6 ospf process-id
area area-id command.
Parameters
process-id Enter the process identification number.
area area-id Specify the OSPF area. The range is from 0 to 65535.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 ospf authentication
Enable IPv6 OSPF on an interface.
Syntax
ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1}
[key-encryption-type] key}}
To remove an IPsec authentication policy from an interface, use the no ipv6
ospf authentication spi number command.
To remove null authentication on an interface to allow the interface to inherit the
authentication policy configured for the OSPFv3 area, use the no ipv6 ospf
authentication null
command.
Parameters
null Causes an authentication policy configured for the area to
not be inherited on the interface.
ipsec spi
number
Security Policy index (SPI) value that identifies an IPsec
security policy. The range is from 256 to 4294967295.
MD5 | SHA1
Authentication type: Message Digest 5 (MD5) or Secure Hash
Algorithm 1 (SHA-1).
key-
encryption-
type
(OPTIONAL) Specifies if the key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
Open Shortest Path First (OSPFv2 and OSPFv3)
989