Command Line Reference Guide

role [active |
passive]
Enter the role that the local system assumes:
• active — The active system initiates the BFD session. Both
systems can be active for the same session.
• passive — The passive system does not initiate a session.
It only responds to a request for session initialization
from the active system.
The default is Active.
Defaults See Parameters.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command provides the flexibility to fine-tune the timer values based on
individual interface needs when you configure the ipv6 ospf bfd command in
CONFIGURATION mode. Any timer values specified with this command overrides
timers set using the bfd all-neighbors command. Using the no form of this
command does not disable BFD if you configured BFD in CONFIGURATION mode.
To disable BFD on a specific interface while BFD is configured in CONFIGURATION
mode, use the keyword disable.
ipv6 ospf cost
Explicitly specify the cost of sending a packet on an interface.
Syntax
ipv6 ospf interface-cost
Parameters
interface-cost
Enter a unsigned integer value expressed as the link-state
metric. The range is from 1 to 65535.
Defaults Default cost based on the bandwidth.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
In general, the path cost is calculated as:
10^8 / bandwidth
Open Shortest Path First (OSPFv2 and OSPFv3)
991