Configuration manual

To reset the number of FP blocks to the default, use the no version of these commands. By default, zero
groups are allocated for the ACL in VCAP. ACL VLAN groups or CAM optimization is not enabled by
default, and you need to allocate the slices for CAM optimization.
To display the number of FP blocks that is allocated for the different VLAN services, you can use the show
cam-acl-vlan command. After CAM configuration for ACL VLAN groups is performed, reboot the
system to enable the settings to be stored in nonvolatile storage. During the initialization of CAM, the
chassis manager reads the NVRAM and allocates the dynamic VCAP regions.
102
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)