Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge T350 Installation and Service Manual
- Contents
- About this document
- PowerEdge T350 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System feet
- System cover
- Air shroud
- Intrusion switch module
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing the drive carrier
- Removing the drive from the drive carrier
- Installing the drive into the drive carrier
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch adapter into a 3.5-inch drive carrier
- Removing a 2.5-inch drive from the 3.5-inch drive adapter
- Installing a 2.5-inch drive into the 3.5-inch drive adapter
- Optional optical drive
- Drive backplane
- Cooling fans
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards
- Optional BOSS S2 module
- Optional IDSDM module
- MicroSD card
- Optional internal USB card
- Optional internal USB memory key
- Power supply unit
- Power interposer board
- System battery
- System board
- Trusted Platform Module
- Control panel
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 3. Rear view of the system (continued)
Item Ports, panels, or slots Icon Description
5 System identification
button
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for 16 seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID button
is enabled in the iDRAC setup.
● If the system stops responding during POST, press and hold the
system ID button (for more than five seconds) to enter the BIOS
progress mode.
6 NIC port (1) The NIC ports are embedded on the LOM card that is connected to the
system board.
7 USB 3.0 port (1) The USB ports are 9-pin, 3.0-compliant. These ports enable you to
connect USB devices to the system.
8 USB 2.0 port (1) The USB ports are 4-pin, 2.0-compliant. These ports enable you to
connect USB devices to the system.
9 NIC port (2) The NIC ports are embedded on the LOM card that is connected to the
system board.
10 iDRAC ethernet port Enables you to remotely access iDRAC. For more information, see the
Integrated Dell Remote Access Controller User's Guide at www.dell.com/
poweredgemanuals.
11 VGA port Enables you to connect a display device to the system. For more
information about the VGA port, see the Dell EMC PowerEdge T350
Technical Specifications on product documentation page.
12 Serial port Enables you to connect a serial device to the system. For more
information about the Serial port, see the Dell EMC PowerEdge T350
Technical Specifications on product documentation page.
PowerEdge T350 system overview 13