Service Manual

Steps

1. Align the notches on the solid-state drive/Intel Optane memory module with the SSD2 slot on the system board.

2. Slide the solid-state drive/Intel Optane memory module into the SSD2 slot on the system board.

3. Place the solid-state drive bracket on the solid-state drive/Intel Optane memory module.

4. Align the screw holes on the solid-state drive bracket with the screw holes on the system board and the palm-rest and keyboard

assembly.

5. Replace the two screws (M2x3) that secure the solid-state drive/Intel Optane memory module to the system board.

Next steps

1. Install the base cover.

2. Follow the procedure in After working inside your computer.

Hard drive

Removing the hard drive

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

About this task

The following image indicates the location of the hard drive and provides a visual representation of the removal procedure.

Removing and installing components