Service Manual

12. Follow the procedure in After working inside your computer.

Power button with fingerprint reader

Removing the power button with fingerprint reader

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the memory module.

4. Remove the WLAN card.

5. Remove the solid-state drive in M.2 slot one.

6. Remove the solid-state drive in M.2 slot two.

7. Remove the battery.

8. Remove the coin-cell battery.

9. Remove the left fan.

10. Remove the right fan.

11. Remove the heat sink.

12. Remove the power-adapter port.

13. Remove the system board.

NOTE: The system board can be removed along with the heat sink.

Steps

1. Locate the power button with fingerprint reader on your computer.

2. Remove the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.

3. Lift the power button with fingerprint-reader, along with the fingerprint-reader cable, off the palm-rest and keyboard assembly.

Removing and installing components