Service Manual

Removing the battery

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow

the steps in Before working inside your computer. After working inside your computer, follow the instructions in After

working inside your computer. For more safety best practices, see the Regulatory Compliance home page at

www.dell.com/regulatory_compliance.

Lithium-ion battery precautions

CAUTION:

• Exercise caution when handling Lithium-ion batteries.

• Discharge the battery as much as possible before removing it from the system. This can be done by disconnecting

the AC adapter from the system to allow the battery to drain.

• Do not crush, drop, mutilate, or penetrate the battery with foreign objects.

• Do not expose the battery to high temperatures, or disassemble battery packs and cells.

• Do not apply pressure to the surface of the battery.

• Do not bend the battery.

• Do not use tools of any kind to pry on or against the battery.

• Ensure any screws during the servicing of this product are not lost or misplaced, to prevent accidental puncture or

damage to the battery and other system components.

• If the battery gets stuck inside your computer as a result of swelling, do not try to release it as puncturing, bending,

or crushing a lithium-ion battery can be dangerous. In such an instance, contact Dell technical support for

assistance. See www.dell.com/contactdell.

• Always purchase genuine batteries from www.dell.com or authorized Dell partners and resellers.

Prerequisites

Remove the base cover.

Procedure for removing the battery for computers

shipped without hard drive

1. Using the pull tab, disconnect the battery cable from the system board, if applicable.

2. Remove the six screws (M2x4) that secure the battery to the palm-rest assembly.

3. Lift the battery, along with its cable, off the palm-rest assembly.

22 Removing the battery