Service Manual

Removing the display assembly

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow

the steps in Before working inside your computer. After working inside your computer, follow the instructions in After

working inside your computer. For more safety best practices, see the Regulatory Compliance home page at

www.dell.com/regulatory_compliance.

Prerequisites

1. Remove the base cover.

2. Replace the wireless card.

3. Remove the graphics-card fan.

4. Remove the processor fan.

5. Remove the heat sink.

Procedure

1. Remove the four screws (M2x4) that secure the display assembly to the palm-rest assembly.

2. Peel the tape that secures the display cable to the system board.

3. Open the latch and disconnect the display cable from the system board.

Removing the display assembly 69