Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antennae
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
NOTE: If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from
the slot.
Next steps
1. Install the processor fan.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
M.2 solid-state drive
Removing the M.2 2230 PCIe solid-state drive (slot-1)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the processor fan.
4. Remove the riser card—optional.
5. Remove the hard-drive assembly.
About this task
The following image(s) indicate the location of the solid-state drive and provide a visual representation of the removal
procedure.
34
Removing and installing components