Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antennae
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Insert the coin-cell battery into the socket with the positive side (+) label facing up and snap the battery in the socket.
2. Place the computer in an upright position.
Next steps
1. Install the optional I/O module.
2. Install the riser card.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the processor fan.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
50 Removing and installing components