User Manual

Table Of Contents
4. Unroute the cable from the routing channel [1] and remove the cable from the battery [2].
Installing the battery
NOTE: If your computer supports a 6-cell battery, it will not support a hard drive.
1. Connect the battery cable to the connector on the battery.
2. Route the battery cable through the routing channel on the battery.
3. Insert the battery into the slot on the computer.
4. Tighten the screws to secure the battery to the computer.
5. Connect the battery cable to the connector on the system board.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
11