User Manual

Table Of Contents
Installing the hard drive assembly
If the system is shipped with hard drive assembly perform the following steps.
1. Insert the hard drive assembly into the slot on the computer.
2. Tighten the screws to secure the hard drive assembly to the computer.
3. Connect the hard drive cable to the connector on the hard drive and on the system board.
4. Install the:
a. battery
b. base cover
5. Follow the procedures in After working inside your system.
Installing the optional M.2 SSD
If the system is shipped with M.2 SSD perform the following steps.
1. Insert the SSD into the connector on the computer.
2. Tighten the screw to secure the SSD to the computer.
3. Install the:
a. battery
b. base cover
4. Follow the procedure in After working inside your computer.
Removing the optional M.2 Solid State Drive (SSD)
If the system is shipped with M.2 SSD perform the following steps.
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the SSD:
a. Remove the screw that secures the SSD to the computer [1].
b. Slide and lift the SSD from the computer [2].
14