Users Guide

Understanding the Printer Menus 201
PS Data Format
Purpose:
To specify PostScript 3 Compatible communication protocol, you can configure the PS Data Format settings.
The change becomes effective after the printer is turned off and then on again.
Va lu e s:
Reset LAN
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting
the printer, all wired network settings are reset to their default values.
Delete All Certificates
Purpose:
To delete all certificates of the printer. After executing this function and rebooting the printer, all certificates are
deleted.
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Fax Line Settings
Purpose:
To configure basic settings for the fax line.
Fax Number
Purpose:
To set the fax number of the printer, which will be printed on the header of a fax message.
NOTE: Ensure to specify Fax Number before using Junk Fax Setup .
Auto
*
Used when auto-detecting the PostScript 3 Compatible communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Binary Used when no special processing is required for data.