Users Guide

228 Understanding the Printer Menus
NFC Authentication
NOTE: The NFC Authentication feature is available on the Dell Cloud Multifunction Printer | H815dw only.
Purpose:
To specify whether to enable the authentication using the NFC authentication card.
Values:
FIPS 140-2 Validation Mode
NOTE: The FIPS 140-2 Validation Mode feature is available on the Dell Smart Multifunction Printer | S2815dn only.
Purpose:
To specify whether to use the FIPS 140-2 Level-1 approved encryption algorithms for RSA modules.
Values:
NOTE: Communication using the following protocols will not be encrypted using FIPS 140-2 Level-1 approved encryption
algorithms even when FIPS 140-2 Validation Mode is enabled. Users are advised to turn them off manually when FIPS 140-2
Validation Mode is enabled:
•SNMP v3
•SMB
• PDF Direct Print
NOTE: This feature may not be available for certain models.
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
NOTE: USB Port feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Values:
PS Data Format
Purpose:
To specify PostScript 3 Compatible communication protocol. You can configure the PS Data Format settings. The
change becomes effective after the printer is turned off and then on again.
Disable
*
Does not permit the authentication using the NFC authentication card.
Enable Permits the authentication using the NFC authentication card.
Disable
*
Allows the use of FIPS 140-2 Level-1 unapproved algorithms.
Enable Allows the use of FIPS 140-2 Level-1 approved encryption algorithms.
Disable Disables the USB interface.
Enable
*
Enables the USB interface.