Operation Manual

270 Loading Print Media
Loading Print Media in Tray1 and the Optional 550-Sheet Feeder
This section describes how to load letterhead. For details about loading print media other than letterhead, see
"Loading Paper."
NOTE: To avoid paper jams, do not remove the tray while printing is in progress.
NOTE: Use only laser print media. Do not use ink jet paper in the printer.
Loading Letterhead (Pre-Printed and Pre-Punched Paper)
The pre-printed paper such as letterhead and pre-punched paper must be inserted bottom edge first with the print
side facing down as shown below.
NOTE: To enable printing with letterhead paper, set Paper Type to Letterhead and Letterhead Duplex Mode to Enable from the
printer driver. Make sure to set
Paper Type to Letterhead from the operator panel even when you print on a single
side of letterhead, pre-printed, or pre-punched paper.
Print media source Print side Page orientation
Tray1 and optional 550-sheet
feeder
Face down Letterhead enters the printer
last
MPF Face down Letterhead enters the printer
last