Operation Manual

42 | Connecting Your Printer to a Computer
b Tap OK.
NOTE:
• A passphrase is an encryption key and may be described on access points or routers. For
details, refer to the manual supplied with the access point or router.
7 Turn off the printer, and then turn it on again.
Wireless LAN connection setting is complete.
After the setting is complete, install the software. See "Installing the Software for
Windows
®
Computers" or "Installing the Software for Macintosh Computers."
Manual SSID Setup
1 Press the (Information) button.
2 Tap the Tools tab Admin Settings Network Wi-Fi Wi-Fi Setup
Wizard.
If Panel Lock Control is set to Enable, enter the password. See "Panel Lock."
3 Select the Manual SSID Setup check box, and then tap Next.
4 Enter the SSID, and then tap Next.
5 Select the network mode from Infrastructure and Ad-hoc according to your
environment, and then tap Next.
If you select Infrastructure, proceed to step 6.
If you select Ad-hoc, proceed to step 7.
NOTE:
• When Wi-Fi Direct is set to Enable, you cannot select Ad-hoc.
6 Select the encryption type from No Security, Mixed mode PSK, WPA2-PSK-AES,
or WEP.
If you do not set security for your wireless network:
a Tap until No Security appears, and then tap No Security.
b Tap OK.
If you use Mixed mode PSK or WPA2-PSK-AES encryption:
a Tap until Mixed mode PSK or WPA2-PSK-AES appears, and then tap the
desired encryption type.
b Tap the Passphrase text box, and then enter the passphrase.
c Tap OK.
If you use WEP encryption:
a Tap until WEP appears, and then tap WEP.
b Tap the WEP Key text box, and then enter the WEP key.
c Tap Transmit Key, and then select the desired transmit key from Auto or WEP
Key 1 to WEP Key 4.
d Tap OK.