Users Guide

6 Route the SAS data cable through the clip on the card and through the channel on the inner side of the chassis.
7 Attach the connector labeled "SAS A" to connector SAS A on the backplane, and attach the connector labeled "SAS B" to connector
SAS B on the backplane.
8 Close the system.
9 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Removing the HBA330 MMZ adapter card
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn o the sled and any attached peripherals, and remove the sled from the MX chassis.
NOTE: Perform a graceful shutdown of the sled to ensure any data in the cache is ushed to the disk before the controller
is removed.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of
the system.
2 Open the system.
3 Locate the HBA card on the system board.
4 Using the blue tab, rotate the lever of the controller.
5 Firmly pull the lever and the front of the controller to disengage the controller from the connector.
6 Lift one end of the card and angle it to disengage from the card connector on the system board.
7 Lift the card from the system board.
NOTE
: To prevent damage to the card, you must hold the card by its edges only.
8 Close the sled.
9 Insert the sled into the MX chassis and turn on the system and any attached MX chassis peripherals.
Deploying Dell HBA cards
19