Users Guide

Figure 12. Removing and installing the HBA330 mini monolithic card
1
storage controller cable 2 storage controller card
3 storage-controller card holder 4 storage controller retention hook
Installing the HBA330 mini monolithic controller
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet.
NOTE
: It is recommended that you always use a static mat and static strap while working on components in the interior of
the system.
2 Open the system.
3 Locate the storage controller card retention hook on the system board and insert the end of the card at an angle into the storage
controller retention hook.
CAUTION
: To prevent damage to the card, you must hold the card by its edges only.
4 Lower the storage controller card to align the screw holes on the card with the screw holes on the connector.
5 Connect the storage controller cable:
a Grasp the cable on both sides of the cable connector and connect to the HBA card.
24
Deploying Dell HBA cards