Users Guide

b Tighten the screws to secure the cable and the card to the system board.
6 Connect the SAS data cable connector to the card.
NOTE: Ensure that you connect the cable according to the connector labels on the cable. The cable does not function
properly if reversed.
7 Route the SAS data cable through the clip on the card and through the channel on the inner side of the chassis.
8 Attach the connector labeled "SAS A" to connector SAS A on the backplane, and attach the connector labeled "SAS B" to connector
SAS B on the backplane.
9 Close the system.
10 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Deploying Dell HBA cards 25