Service Manual
Table Of Contents
- OptiPlex 3000 Thin Client Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 3000 Thin Client
- Side cover
- Speaker
- Solid-state drive assembly
- Memory
- WLAN card
- Optional modules
- Removing the optional Type-C module
- Installing the optional Type-C module
- Removing the optional HDMI module
- Installing the optional HDMI module
- Removing the optional Serial module
- Installing the optional Serial module
- Removing the optional PS/2 keyboard/mouse module
- Installing the optional PS/2 keyboard/mouse module
- Coin-cell battery
- Heat sink
- Antenna Assembly
- SMA Antenna Assembly
- System board
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Table 11. System setup options—Security menu (continued)
Security
By default, the option is disabled.
SMM Security Mitigation Enable or disable SMM Security Mitigation.
By default, the option is disabled.
Data Wipe on Next Boot
Start Data Wipe Enable or disable the data wipe on next boot.
By default, the option is disabled.
Absolute Enable or disable or permanently disable the BIOS module interface of the
optional Absolute Persistence Module service from Absolute software.
By default, the Enable Absolute option is enabled.
UEFI Boot Path Security Controls whether or not the computer will prompt the user to enter the admin
password (if set) when booting to a UEFI boot device from the F12 boot menu.
By default, the Always Except Internal HDD option is enabled.
Table 12. System setup options—Passwords menu
Passwords
Admin Password Set, change, or delete the administrator password.
System Password Set, change, or delete the computer password.
M.2 PCIe SSD-0 Set, change, or delete the M.2 PCIe SSD-0 password.
Password Configuration
Upper Case Letter Reinforces password must have at least one upper case letter.
By default, the option is disabled.
Lower Case Letter Reinforces password must have at least one lower case letter.
By default, the option is disabled.
Digit Reinforces password must have at least one digit.
By default, the option is disabled.
Special Character Reinforces password must have at least one special character.
By default, the option is disabled.
Minimum Characters Set the minimum characters allowed for password.
Password Bypass When enabled, this always prompts for computer and internal hard drive
passwords when powered on from the Off state.
By default, the Disabled option is enabled.
Password Changes
Enable Non-Admin Password Changes Enable or disable to change computer and hard drive password without the
need for admin password.
By default, the option is enabled.
Admin Setup Lockout
Enable Admin Setup Lockout Enables administrators control over how their users can or cannot access BIOS
setup.
By default, the option is disabled.
Master Password Lockout
50 BIOS setup