Administrator Guide
b Click Online.
c On the ribbon, in the Online Protection group, click Congure.
Figure 42. Congure Online Protection
d On the Recovery Folder Settings page, point to the new volume (or folder on that volume) that you added.
Figure 43. Recovery Folder Settings
5 Now recover the VM.
6 After you recover the VM, clean up the conguration.
a Recongure the DPM staging area to point to the original location (E:\StagingArea).
b Remove the iSCSI connection by disconnecting it via the iSCSI initiator.
c Delete the VHD from the source server.
Recovering DPM from DPM failures
You can use DPM to back up and recover management infrastructure components. If DPM itself fails, you cannot recover from subsequent
component failures. This section describes some of the DPM failure scenarios and the steps that are needed to recover from DPM server
failures.
Operations
85