User Manual
Table Of Contents
- Inspiron 5580 Service Manual
- Before working inside your computer
- After working inside your computer
- Safety instructions
- Recommended tools
- Screw list
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the memory modules
- Replacing the memory modules
- Removing the wireless card
- Replacing the wireless card
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the fan
- Replacing the fan
- Removing the solid-state drive/Intel Optane memory module
- Replacing the solid-state drive/Intel Optane memory module
- Removing the hard drive
- Replacing the hard drive
- Removing the I/O board
- Replacing the I/O board
- Removing the touchpad
- Replacing the touchpad
- Removing the speakers
- Replacing the speakers
- Removing the heat sink
- Replacing the heat sink
- Removing the display assembly
- Replacing the display assembly
- Removing the power button with fingerprint reader
- Replacing the power button with fingerprint reader
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the system board
- Replacing the system board
- Removing the palm-rest and keyboard assembly
- Replacing the palm-rest and keyboard assembly
- Device drivers
- System setup
- Troubleshooting
Removing the display assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the wireless card.
Procedure
1 Peel o the tape that secures the I/O-board cable to the I/O board.
2 Note the routing and remove the I/O-board cable from the routing guides.
3 Peel o the tape that secures the display cable to the display cable connector.
4 Open the latch and disconnect the display cable from the system board.
5 Remove the display cable from the routing guide.
6 Remove the ve screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
7 Open the display at an angle of 90 degrees.
30
50 Removing the display assembly