User's Manual

Using the Local RACADM Command Line Interface 153
Adding an iDRAC User
To add a new user to the iDRAC, perform the following steps:
1
Set the user name.
2 Set the password.
3 Set the Login to iDRAC user privilege.
4 Enable the user.
Example
The following example describes how to add a new user named "John" with a
"123456" password and login privileges to the iDRAC:
racadm config -g cfgUserAdmin -o cfgUserAdminUserName
-i 2 john
racadm config -g cfgUserAdmin -o cfgUserAdminPassword
-i 2 123456
racadm config -g cfgUserAdmin -o cfgUserPrivilege -i 2
0x00000001
racadm config -g cfgUserAdmin -o cfgUserAdminEnable
-i 2 1
To verify the new user, use one of the following commands:
racadm getconfig -u john
racadm getconfig –g cfgUserAdmin –i 2
Enabling an iDRAC User With Permissions
To grant a user a specific administrative (role-based) permissions, set the
cfgUserAdminPrivilege property to a bitmask constructed from the values
show in Table 9-2:
Table 9-2. Bit Masks for User Privileges
User Privilege Privilege Bit Mask
Login to iDRAC 0x0000001
Configure iDRAC 0x0000002
Configure Users 0x0000004