Reference Guide

Synopsis
• To view the FQDD's of system performance monitoring sensors
racadm systemperfstatistics view
• To list the usage statistics of a specific sensor
racadm systemperfstatistics <sensor_FQDD>
• To reset the utilization peaks of system performance monitoring sensors
racadm systemperfstatistics PeakReset <FQDD>
• To run the peakreset operation you must have configure iDRAC privilege.
Examples:
• To view the FQDD's of system performance monitoring sensors
racadm systemperfstatistics view
[key = iDRAC.Embedded.1#SystemBoardCPUUsageStat]
[key = iDRAC.Embedded.1#SystemBoardIOUsageStat]
[key = iDRAC.Embedded.1#SystemBoardMEMUsageStat]
[key = iDRAC.Embedded.1#SystemBoardSYSUsageStat]
• To list the usage statistics of a specific sensor
racadm systemperfstatistics iDRAC.Embedded.1#SystemBoardCPUUsageStat
Minimum Readings
Last Hour = 0% [At Mon, 05 May 2017 17:13:04]
Last Day = 0% [At Mon, 05 May 2017 15:59:53]
Last Week = 0% [At Mon, 05 May 2017 15:59:53]
Maximum Readings
Last Hour = 0% [At Thu, 01 Jan 1970 00:00:00]
Last Day = 0% [At Thu, 01 Jan 1970 00:00:00]
Last Week = 0% [At Thu, 01 Jan 1970 00:00:00]
Average Readings
Last Hour = 0%
Last Day = 0%
Last Week = 0%
Peak Readings
Last Week 0% [At Mon, 05 May 2017 15:58:35]
• To reset the peak utilization of a specific sensor
racadm systemperfstatistics PeakReset iDRAC.Embedded.1#SystemBoardCPUUsageStat
RAC1163: The peak utilization value of Out-Of-Band performance monitoring sensor CPU Usage
is successfully reset.
techsupreport
Description
Allows you to perform the technical support report operations. The type of operations are:
• collect — Collects the technical support report data to export. You can specify the various types of logs to
be included in the report.
This operation generates a Job ID. Use this Job ID to check the status of the collect operation. To run this
operation, you must have the Server Control Commands permission.
•
export — Exports the collected Tech Support Report data. To run this subcommand, you must have the
Execute Server Control Commands permission.
• getupdatetime — Gets the timestamp of the last operating system application data collection.
• updateosapp — Updates the operating system application data collection. To run this subcommand, you
must have the Execute Server Control Commands permission.
140 RACADM Subcommand Details