Reference Guide

Examples
• To collect the system information data.
racadm techsupreport collect —t <type of logs>
• To collect the system information and TTYLog data.
racadm techsupreport collect -t SysInfo,TTYLog
• To collect the operating system application data.
racadm techsupreport collect -t OSAppAll
• To export the collected Tech Support Report, to a CIFS share.
racadm techsupreport export -l //192.168.0/share -u myuser -p xxx
• To export the collected Tech Support Report, to an NFS share.
racadm techsupreport export -l 192.168.0:/share
• To export the collected Tech Support Report to the local file system.
racadm techsupreport export -f tsr_report.zip
testemail
Table 8. Details of testemail
Description
Sends a test email from iDRAC to a specified destination. Prior to running the test email command, make sure that the
SMTP server is configured.
The specified index in the idrac.EmailAlert group must be enabled and configured properly. For more information,
see
iDRAC RACADM CLI Guide available at www.dell.com/idracmanuals.
Synopsis
racadm testemail -i <index>
Input -i <index> — Specifies the index of the email alert to test.
Output Success: Test e-mail sent successfully Failure: Unable to send test e-mail
Example
Commands for the idrac.EmailAlert group:
• Enable the alert.
racadm set idrac.EmailAlert.1.Enable 1
• Set the destination email address.
racadm set idrac.EmailAlert.1.Address [e-mail]
• Set the custom message that is sent to the destination email address.
racadm set idrac.emailalert.1.CustomMsg "This is a test!"
• Make sure that the SMTP IP address is configured properly.
racadm set idrac.remotehosts.SMTPServerIPAddress 192.168.0
• View the current email alert settings.
racadm get idrac.EmailAlert.<index>
where <index> is a number from 1 to 8.
142 RACADM Subcommand Details