Reference Guide

Output Firmware update job for <filename> is initiated.
This firmware update job may take several minutes to complete depending on the component or firmware being
updated. To view the progress of the job, run the
racadm jobqueue view command.
For repository update command, the output is:
Update from repository operation has been initiated. Check the progress of
the operation using "racadm jobqueue view -i JID_809364633532" command.
For devices that perform update process without rebooting the host, the update status changes from
Downloading to Completed. For devices that require host reboot to perform update process, the update status
changes from
Downloading to Scheduled. When the status is displayed as Scheduled, reboot the host to
start the update process.
The following devices require host reboot to perform the update process:
• Backplanes
• BIOS
• Complex programmable logic device (CPLD)
• Hard disk drives
• Solid state drives (SSD)
• Network interface cards (NIC) or Fibre Channel (FC) cards
• PCIe SSD devices
• Power supply unit (PSU)
• Storage controllers
RACADM Subcommand Details
147