Reference Guide
Input Valid options:
• -u — Specifies the user name of the remote share that stores the catalog file.
NOTE: For CIFS, enter the domain name as domain or username.
• -p — Specifies the password of the remote share that stores the catalog file.
• -l — Specifies the network share (NFS, CIFS, FTP, TFTP,HTTP, or HTTPS) location of the catalog file. IPv4
and IPv6 addresses are supported.
• -f — Specifies the catalog location and the filename. If the filename is not specified, then the default file used
is
catalog.xml.
NOTE: If the file is in a subfolder within the share location, then enter the network share
location in the –l option and enter the subfolder location and the filename in the –f option.
• -ph — Specifies the FTP/HTTP proxy host name.
• -pu — Specifies the FTP/HTTP proxy user name.
• -pp — Specifies the FTP/HTTP proxy password.
• -po — Specifies the FTP/HTTP proxy port.
• -pt — Specifies the FTP/HTTP proxy type.
• -time — Specifies the time to schedule an autoupdate in the HH:MM format. This option must be specified.
• -dom — Specifies the day of month to schedule an autoupdate. Valid values are 1–28, L (Last day) or '*'
(default — any day).
• -wom — Specifies the week of month to schedule an autoupdate. Valid values are 1–4, L (Last week) or '*'
(default — any week).
• -dow — Specifies the day of week to schedule an autoupdate. Valid values are sun, mon, tue, wed, thu, fri,
sat, or '*' (default — any day).
NOTE:
The -dom, -wom, or -dow option must be included in the command for the autoupdate
schedule. The * value for the options must be included within ' ' (single quotation mark).
• If the -dom option is specified, then the -wom and -dow options are not required.
• If the-wom option is specified, then the-dow is required and -dom is not required.
• If the-dom option is non-'*', then the schedule repeats by month.
•
If the-wom option is non-'*', then the schedule repeats by month.
• If the-dom and -wom options are '*' and the -dow option is non-'*', then the schedule repeats
by week.
• If all the three -dom, -wom and -dow options are '*', then the schedule repeats by day.
• -rp — Specifies the repeat parameter. This parameter must be specified.
• If the-dom option is specified, then the valid values for -rp are 1–12.
• If the-wom option is specified, then the valid values for -rp are 1–52.
• If the-dow option is specified, then the valid values for -rp are 1–366.
• -a — Applies reboot (1 — Yes, 0 — No). This option must be specified.
42
RACADM Subcommand Details