CLI Guide

• Create a partition from a remote image.
racadm vflashpartition create -i 1 -o Drive1 -e cddvd -t image -l
//ipaddress/sharefolder/isoimge.iso -u username -p xxx
A new partition is created. By default, the created partition is read-only. This command is case-sensitive for the
image filename extension. If the filename extension is in uppercase, for example FOO.ISO instead of FOO.iso,
then the command returns a syntax error.
NOTE:
• This feature is not supported in Local RACADM.
• Creating vFlash partition from an image file on the CFS or NFS IPv6 enabled network share is
not supported.
• Delete a partition.
racadm vflashpartition delete -i 1
• Status of operation on partition 1.
racadm vflashpartition status -i 1
• Status of all the existing partitions.
racadm vflashpartition status -a
• List all the existing partitions and its properties.
racadm vflashpartition list
vmdisconnect
Table 114. Details of vmdisconnect
Description Allows you to end another Virtual Media session. After the session ends, the web-based interface reflects the
correct connection status.
Enables an iDRAC user to disconnect all active Virtual Media sessions. The active Virtual Media sessions are
displayed on iDRAC web-based interface or by running the RACADM subcommands
remoteimage or
getssninfo.
To run this subcommand, you must have the Access Virtual Media permission.
Synopsis
racadm vmdisconnect
RACADM Subcommand Details 157