CLI Guide

Synopsis
racadm frontpanelerror show
racadm frontpanelerror hide
Input
• show — to view the errors currently being displayed on the LCD screen.
• hide — to hide the errors currently being displayed on the LCD screen.
Example
• racadm frontpanelerror show
Front Panel Error—Show Enabled.
• racadm frontpanelerror hide
Front Panel Error—Hide Enabled.
fwupdate
Table 23. Details of fwupdate
Description
Allows you to update the firmware. You can:
• Check the firmware update process status.
• Update iDRAC firmware from FTP or TFTP server by providing an IP address and optional path.
• Update iDRAC firmware from the local file system using Local and Remote RACADM.
• Roll back to the standby firmware.
To use this subcommand, you must have Configure iDRAC permission.
NOTE: This command is only for iDRAC firmware update. For any other firmware update like BIOS or
DUPs, use Update subcommand.
NOTE: If the iSM is exposed on the host server, you may see the Firmware update operation
is already in progress error.
Synopsis
racadm fwupdate -s
racadm fwupdate -g -u -a <TFTP_Server_IP_Address>
[-d <path> [--clearcfg]
racadm -r <iDRAC IP_Address> -u <username> -p <password> fwupdate -f
<ftpserver ip> <ftpserver username> <ftpserver password> -d <path> where path
is the location on the ftp server where firmimg.d7 is stored.
racadm fwupdate -r
racadm fwupdate -p -u [-d <path>]
NOTE: When attempting to run firmware update task, if the firmware image path length is greater
than 256 characters, remote RACADM client exits with the error message "ERROR: Specified
path is too long".
Input
• —u—The update option performs a checksum of the firmware update file and starts the update process. This
option may be used along with the —g or —p options. At the end of the update, iDRAC performs a soft reset.
• —s—This option returns the status of the update process.
• -a—The -a option specifies TFTP server IP address that is used for firmware image. This option must be used
with the -g option.
• -clearcfg—The -clearcfg option removes the previous iDRAC configuration after firmware update.
58 RACADM Subcommand Details