Users Guide

• Enabled with PXE to use the NIC for PXE boot.
• Enabled with iSCSI to use the NIC to boot from an iSCSI target.
Modifying device settings
To modify device settings using the Advanced Hardware Configuration:
NOTE: You can also modify the device settings by using the System Setup utility during startup. For more information
about the System Setup utility, see Using the system setup program and boot manager.
1.
Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
2. In the left pane, select System Setup.
3. In the right pane, click Advanced Hardware Configuration.
4. Select the device you want to configure.
Based on the configuration setting changes, the following message may be displayed:
One or more of the settings requires a reboot to be saved and activated. Do you want to
reboot now?
5. Select No to continue making additional configuration changes or select Yes to save the changes and exit the wizard.
All changes are applied during the next system restart.
Collect system inventory on restart
When you enable the Collect System Inventory On Restart (CSIOR) property, hardware inventory and part configuration information
is discovered and compared with previous system inventory information on every system restart.
NOTE:
By default, the CSIOR property is enabled.
Updating server inventory information
To enable collecting system inventory on restart:
1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
2. In the left pane, click Hardware Configuration.
3. In the right pane, select Hardware Inventory.
4. Click Collect System Inventory on Restart.
5. Under Collect System Inventory on Restart, click Enabled, and then click Finish.
The system inventory is updated after the next restart.
Configuring local FTP server
If your organization’s users are on a private network that does not have access to external sites, specifically downloads.dell.com, you can
provide firmware updates from a locally-configured FTP server. The users in your organization can access updates or drivers for their Dell
EMC server from the local FTP server instead of downloads.dell.com. A local FTP server is not required for users, who have access to
downloads.dell.com through a proxy server. Check downloads.dell.com frequently to make sure your local FTP server has the most recent
updates.
FTP authentication
Although you must provide the user name and password for the FTP server, Lifecycle Controller supports anonymous login to the FTP
server using the FTP server address to download the catalog information. If you use a firewall, you should configure it to allow outgoing
FTP traffic on port 21. The firewall must be configured to accept incoming FTP response traffic.
Requirements for a local FTP server
The following requirements apply when configuring a local FTP server.
Configure
47