Users Guide

and also based on persistence policy setting for that power state. This provides more flexibility in deployments that need rapid re-
configuration of system workloads to another system.
The virtual addresses are:
• Virtual MAC Address
• Virtual iSCSI MAC Address
• Virtual FIP MAC Address
• Virtual WWN
• Virtual WWPN
NOTE: When you clear the persistence policy, all the virtual addresses are reset to the default permanent address set at
the factory.
NOTE: Some cards with the virtual FIP, virtual WWN, and virtual WWPN MAC attributes, the virtual WWN and virtual
WWPN MAC attributes are automatically configured when you configure virtual FIP.
Using the IO Identity feature, you can:
• View and configure the virtual addresses for network and fibre channel devices (for example, NIC, CNA, FC HBA).
• Configure the initiator (for iSCSI and FCoE) and storage target settings (for iSCSI, FCoE, and FC).
• Specify persistence or clearance of the configured values over a system AC power loss, cold, and warm system resets.
The values configured for virtual addresses, initiator and storage targets may change based on the way the main power is handled during
system reset and whether the NIC, CNA, or FC HBA device has auxiliary power. The persistence of IO identity settings can be achieved
based on the policy setting made using iDRAC.
Only if the I/O identity feature is enabled, the persistence policies take effect. Each time the system resets or powers on, the values are
persisted or cleared based on the policy settings.
NOTE: After the values are cleared, you cannot re-apply the values before running the configuration job.
Supported cards for IO Identity Optimization
The following table provides the cards that support the I/O Identity Optimization feature.
Table 43. Supported cards for I/O Identity Optimization
Manufacturer Type
Broadcom
• 5719 Mezz 1GB
• 5720 PCIe 1 GB
• 5720 bNDC 1 GB
• 5720 rNDC 1 GB
• 57414 PCIe 25GbE
Intel
• i350 DP FH PCIe 1GB
• i350 QP PCIe 1GB
• i350 QP rNDC 1GB
• i350 Mezz 1GB
• i350 bNDC 1GB
• x520 PCIe 10GB
• x520 bNDC 10GB
• x520 Mezz 10GB
• x520 + i350 rNDC 10GB+1GB
• X710 bNDC 10GB
• X710 QP bNDC 10GB
• X710 PCIe 10 GB
• X710 + I350 rNDC 10GB+1GB
• X710 rNDC 10GB
• XL710 QSFP DP LP PCIe 40GE
• XL710 QSFP DP FH PCIe 40GE
• X550 DP BT PCIe 2 x 10 Gb
Inventorying, monitoring, and configuring network devices 183