Users Guide

The Backup and Export Server Profile page is displayed.

2. Select one of the following to save the backup file image:

• Network to save the backup file image on a CIFS or NFS share.

• HTTP or HTTPS to save the backup file image using HTTP/S file transfer.

3. Enter the backup File Name, Backup File Passphrase (optional) and Confirm Passphrase.

4. If Network is selected as the file location, enter the network settings.

NOTE: While specifying the network share settings, it is recommended to avoid special characters for user name and

password or percent encode the special characters.

For information about the fields, see the iDRAC Online Help

5. Click Backup Now.

A recurring job is represented in the job queue with a start date and time of the next scheduled backup operation. Five minutes after

the first instance of the recurring job starts, the job for the next time period is created. The backup server profile operation is

performed at the scheduled date and time.

Scheduling automatic backup server profile using RACADM

To enable automatic backup use the command:

racadm set lifecyclecontroller.lcattributes.autobackup Enabled

To schedule a backup server profile operation:

racadm systemconfig backup –f <filename> <target> [-n <passphrase>] -time <hh:mm> -dom

<1-28,L,’*’> -dow<*,Sun-Sat> -wom <1-4, L,’*’> -rp <1-366>-mb <Max Backups>

To view the current backup schedule:

racadm systemconfig getbackupscheduler

To disable automatic backup, use the command:

racadm set LifeCycleController.lcattributes.autobackup Disabled

To clear the backup schedule:

racadm systemconfig clearbackupscheduler

For more information, see the iDRAC RACADM CLI Guide available at www.dell.com/idracmanuals.

Importing server profile

You can use the backup image file to import or restore the configuration and firmware for the same server without rebooting the server.

Import feature is not licensed.

NOTE:

For the restore operation, the system Service Tag and the Service Tag in the backup file must be identical. The

restore operation applies to all system components that are same and present in the same location or slot as captured in

the backup file. If components are different or not in the same location, they are not modified and restore failures is

logged to the Lifecycle Log.

Before performing an import operation, make sure that Lifecycle Controller is enabled. If Lifecycle Controller is disabled, and if you initiate

the import operation, the following message is displayed:

Lifecycle Controller is not enabled, cannot create Configuration job.

When the import is in-progress, if you initiate an import operation again, the following error message is displayed:

Restore is already running

Import events are recorded in the Lifecycle Log.

Setting up managed system