Service Manual

Removing the camera

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow

the steps in Before working inside your computer. After working inside your computer, follow the instructions in After

working inside your computer. For more safety best practices, see the Regulatory Compliance home page at

www.dell.com/regulatory_compliance.

Topics:

• Prerequisites

• Procedure

Prerequisites

1. Remove the base cover.

2. Remove the battery.

3. Remove the display assembly.

4. Follow the procedure from step 1 to step 3 in “Removing the display panel”.

Procedure

CAUTION:

Place the display-panel assembly on a soft and clean surface to avoid scratching the display.

1. Using a plastic scribe, pry the camera module off the display panel.

2. Turn the camera over and peel off the tape to disconnect the camera cable from the camera module.

Figure 34. Camera

display panel 2. plastic scribe

3. camera module 4. camera cable

Removing the camera 69